AUDIO-TECHNICA AT33SPTG/2 DUAL MOVING COIL CARTRIDGE

$899.00

Product Details

The AT33PTG/II dual moving coil cartridge features a Microlinear stylus that, with its small curvature radius, delivers low-distortion, high-range performance, even when playing the inner circumference of a record. The Microlinear stylus, which has an average life span of around 1,000 hours, is mounted on a nude tapered boron cantilever with a double damper for reduced weight and better audio quality.

The cartridge’s two coils provide excellent channel separation and are affixed within a strong, lightweight mold made of hard resin to greatly reduce unwanted vibration. The cartridge uses a neodymium magnet and a permendur yoke for dramatically enhanced magnetic energy. The PCOCC (Pure Copper by Ohno Continuous Casting) coils ensure pure audio transmission.

FEATURES

Moving coil cartridge with Microlinear stylus delivers exquisite, full-range audio reproduction
Advanced tapered boron cantilever and reduced coil weight improve the audio quality, particularly in the higher frequencies
Neodymium magnet and permendur yoke dramatically enhance the magnetic energy
PCOCC (Pure Copper by Ohno Continuous Casting) coil enables pure signal transfer
High-separation, wide-response dual moving coil
Strong, rigid housing limits unnecessary vibration
Precision-cast hard aluminum alloy body enhances rigidity and the signal-to-noise ratio

SPECIFICATIONS

Cartridge & Stylus
Frequency Response	15-50,000 Hz
Channel Separation	30 dB (1 kHz)
Vertical Tracking Angle	23°
Vertical Tracking Force	1.8-2.2 g (2.0 g standard)
Recommended Load Impedance	More than 100 ohms (when head amplifier is connected)
Coil Impedance	10 ohms (1 kHz)
DC Resistance	10 ohms
Coil Inductance	22 µH (1 kHz)
Output Voltage	0.3 mV (at 1 kHz, 5 cm/sec)
Output Channel Balance	0.5 dB (1 kHz)
Stylus Shape	Microlinear
Cantilever	Gold-plated nude tapered boron
Static Compliance	40 x 10-6 cm/dyne
Dynamic Compliance	10 x 10-6 cm/dyne (100 Hz)
Mounting	Half-inch
Dimensions	16.0 mm (0.63") H × 16.6 mm (0.65") W × 26.5 mm (1.04") D
Accessories Included	Non-magnetic screwdriver; 2 washers; 2 nuts; cartridge installation screws (13 mm × 2, 19 mm × 2); plastic protector; brush; PCOCC lead wire set
Mounting Feature	Half-inch mount
Stylus Curvature Radius	2.2 x 0.12 mil
Stylus Size	Nude square shank
Weight	6.9 g (0.24 oz)
Notes	Note: Moving coil cartridges require receivers or preamps with compatible inputs; their stylus assemblies are not field-replaceable.